I started with a blank piece of linoleum and traced my logo design on it. After I got the design traced on to the linoleum I learned about the stop block and the carving tool. You start carving by putting the stop block underneath your linoleum. After that you use the carving tool and wiggle it back and forth to carve out you're design. As you are carving you always be sure to keep you're free hand behind you're carving hand. After you get you're design completely carved out then you are ready to print. To print you have to have a brayer, cookie tray, and printmaking ink. You put ink on the tray and roll it out so it is nice and sticky. Then you use the brayer and put ink on the linoleum. After you have ink on you're linoleum you put it on you're paper and apply with pressure. I would recommend to do multiple prints for best results. Then let you're prints dry and you are done.
I like how you not only told us your steps, but had pictures to go along with it. I also enjoyed the colors you choose. It's neat how you made the letters fit into your fish. Good job!